DTC P0300 Random Engine Miss Fire Condition

DTC P0300 is a Random Engine Miss Fire Condition

An engine miss fire feels like a bumping sensation. Most of the time, this is noticed by the driver when accelerating. A miss fire condition may cause the Check Engine Light to turn on or start flashing at you.

Carbon tracking on a spark plug

This is a spark plug with carbon tracking. The dark black lines running left to right in the center of the image is a carbon trail caused by a faulty spark plug wire. This type of condition will cause a single cylinder miss fire.

If an engine miss fire condition is causing poor tail pipe emissions, the check engine light will start to flash on and off.

When you see the check engine light flashing at you, do not continue to drive the car. Get it in for repairs right away. The catalytic converter maybe damaged if you continue to drive the car with the check engine light flashing.

catalytic converter failure core melted

A Catalytic Converter damaged by a miss fire condition. A miss fire condition will melt down a converter very quickly.

A catalytic converter is not chump change. On a Nissan Pathfinder, I just replaced both front catalytic converters on the Nissan and it was related to a miss fire condition. It was over $1,400.00 just for the dealer cats.

Worn spark plugs, causing engine code P0300

This set of worn spark plugs was causing a DTC P0300 on a Ford 4.2 V6. The plugs are 8 years old with 102,000 miles of use. The engine needed more parts than just spark plugs. This set of plugs also shows oil build up, the engine was due for a valve job on top of all the other needs.

If the check engine light is flashing, get it in for repairs!

OBD2 cars today can store a code that will direct the mechanic to look at a specific area.

A good example of this is when you have a DTC P0302 miss fire detected on cylinder #2, you have a place to look (cylinder #2 has a miss fire). You just have to look at things that would affect cylinder #2.

Oil fouled spark plug

Oil fouled spark plug, this plug was causing a single cylinder miss fire. (DTC P0304)

On a DTC P0300, this is a random miss fire condition that could be caused by anything. Anything that changes the air/fuel mixture to all of the cylinders in the engine at the same time.

A dirty MAF sensor can cause this type of change to all the cylinders.

MAF: Mass Air Flow Sensor, is a sensor that takes reading of the incoming air into the engine and sends a signal to the computer. The signal is used to make fuel system, cam timing and ignition timing adjustments.

The driver may not feel the engine miss fire with a DTC P0300, but the driver should see the check engine light turn on. Other things the driver may notice. The engine may feel like it is not responding crisply or the driver may notice that the fuel economy has been poor.

A couple other things that can cause a DTC P0300. Poor engine compression or an engine that is out of time due to a faulty timing belt or timing chain. A large centrally located vacuüm leak or a restricted exhaust system.

——————————————————————————————–

DTC P0300 Defined: Random Cylinder Miss Fire, this condition could be caused by any parts attached to the engine or parts inside the engine. You have to look for any condition that will change the air/fuel mixture, spark or compression to all the cylinders at the same time.

DTC P0301 Defined: Miss Fire on cylinder #1 or any cylinder that the code lists. (P0301, P0302, P0303, P0304) The last number in the DTC is pointing to the cylinder that set the code.

 

It’s all good under the hood. Anthony Xavier ASE Master Technician

copyright: All rights reserved @ HeyAnthonyAZ.com 2013